Services | Show Low Roofing & Maintenance | Show Low, AZ
Show Low Roofing & Maintenance provides residential and commercial roofing services throughout Show Low and Prescott Valley, Second Mesa, Tonalea, Woodruff, Bylas. Free estimates on every service listed here.
Roof Replacement
After tear-off, we always check decking and replace what's needed. Soft spots mean moisture intrusion. The old roof was leaking longer than you realized. We use 7/16" or 15/32" CDX plywood depending on rafter spacing. New decking costs $75-$120 per sheet installed. We only replace what's actually damaged.
Get a Free Quote →Roof Repair
We warranty every repair for 5 years. If the same area leaks again due to our workmanship, we come back free. That warranty is in writing and it means something because we're a local Show Low company. We're not disappearing.
Get a Free Quote →Storm Damage Repair
Wind speeds above 60 mph cause shingle tab lift and adhesive seal failure per ASTM D7158 testing protocols. Our Show Low inspectors check the entire windward exposure. Not just the obvious damage. Poor ventilation causes ice dams which cause water intrusion under the shingle field during freeze-thaw cycles. We document all contributing factors so your insurance claim covers root-cause repairs, not just surface patches.
Get a Free Quote →New Roof Installation
New construction roofing in Show Low starts with getting the design details right before materials arrive. Roof pitch, attic ventilation needs, snow load requirements, and local code amendments all affect material selection and installation methods. We coordinate with your general contractor or architect to ensure the roof system matches the building specifications.
Get a Free Quote →Metal Roofing
Standing seam metal with Kynar 500 PVDF fluoropolymer finish. The gold standard for color retention and chalk resistance. We install Sheffield Metals and McElroy Metal panels in 24-gauge Galvalume steel. UL 2218 Class 4 impact resistance (qualifies for insurance discounts in most Arizona markets). UL 790 Class A fire rating. Wind uplift rated to 140+ mph per ASTM E1592 testing. Concealed Z-clips allow thermal expansion without stress on fasteners. That's what makes standing seam leak-proof.
Get a Free Quote →Shingle Roofing
The difference between a cheap shingle roof and a quality one comes down to the system underneath. Shingles are only the outer layer. Ice and water shield in the valleys, synthetic underlayment across the deck, proper starter strip with factory adhesive, correct nailing pattern. That's what makes a shingle roof last in Arizona's weather.
Get a Free Quote →Flat Roofing
Modified bitumen is the best choice for residential flat roofs and low-traffic commercial applications in Show Low. We torch-apply SBS-modified base and cap sheets in a two-ply system. Granulated cap sheet handles foot traffic and UV exposure. 15-20 year warranty.
Get a Free Quote →Commercial Roofing
Your commercial roof has HVAC units, exhaust fans, plumbing vents, and satellite dishes punching through it. Every penetration is a potential leak point. We install prefabricated curbs, custom-welded flashings, and pitch pans that handle foot traffic and thermal cycling without failing.
Get a Free Quote →Gutter Installation
Gutter replacement in Show Low costs $8-$15 per linear foot installed. That includes hangers, end caps, outlet drops, miters, and at least two downspout runs. Copper is $25-$40 per foot. We give exact pricing in the estimate. No ranges.
Get a Free Quote →Roof Inspection
Roof inspections are free for Show Low homeowners. No strings, no obligation to hire us for repairs. If your roof is fine, we say so. If it needs attention, you get an honest assessment of what's going on and what it'll cost to fix.
Get a Free Quote →Emergency Roof Repair
Our trucks carry 20x30 reinforced tarps, 2x4 lumber, plywood sheets, pipe boots, ridge cap shingles, flashing stock, roofing cement, and neoprene screws. We show up ready to secure your roof, not ready to schedule a follow-up appointment.
Get a Free Quote →Skylight Installation
VELUX FS (fixed) and VS (vented) skylights installed with EDL flashing kits for shingle roofs. The multi-step flashing integrates with the surrounding shingle courses per IRC R903.2. We frame the curb with doubled 2x8 or 2x10 lumber (depending on rafter depth), install ice and water shield membrane around the entire curb perimeter, then set the skylight with factory sealant before weaving step flashing into the field. Top headwall flashing tucks under the upslope shingle course. Bottom sill pan diverts water onto the downslope shingles. Zero exposed sealant joints. Mechanical flashing only.
Get a Free Quote →